Fliers Commemorative Badge, Prinzen Size (in silver)
CATEGORY: Version
SKU: 03.GEM.0103.101.04.000
Estimated market value:
Estimated market value:
A Commemorative Flyer Badge constructed of silver, the obverse presents an eagle in flight over a rural landscape, bordered by a wreath made of laurel leaves on the left and oak leaves on the right, surmounted by an imperial crown, tied with a ribbon below, the reverse presents a vertical pinback, oval hinge well, straight pin, and thick wire catch, eagle’s reverse stamped “800,” measures 28.75 mm (w) x 45.65 mm (h), weighs 15.8 grams, and in extremely fine condition.
The Fliers Commemorative Badge was introduced by Emperor Wilhelm II on January 27, 1914. It is silver-coloured and was worn in the centre of the left breast.
It was worn by members of the air force that were no longer considered for service in the event of mobilisation, but had served for a minimum of three consecutive years prior. However, members were also considered eligible if they had to retire due to injuries sustained during active service.
The Fliers Commemorative Badge is in the same general design as the Pilot Badge and the Observer Badge. Its shape is oval. It is framed by laurel on the left and oak leaves on the right side, with an Imperial crown at the top and a bow at the bottom. In the centre, differing from the Pilot and Observer Badges, is an eagle in flight, facing to the viewer’s left. Below it is the same landscape design as on the Pilot’s Badge, but above the hills and behind the eagle the badge is cut out with the reverse pinback being visible.
Badges measure approximately 45mm in width and 72mm in height. They weigh between 10 and 40g. The large variation is due to different materials and designs being used.
As with the Pilot and Observer Badges, the company of C. E. Juncker produced Fliers Commemorative Badges made of silver during the war years. Genuine examples are rarely available to collectors these days.
Most Fliers Commemorative Badges were produced during the early Weimar Republic years of 1919 and 1920. These were made of either silver or brass. Most of the post-war pieces produced and sold all the way up to 1945 were made by manufacturer P. Meybauer.
Some badges were produced in a reduced size, the so-called “Prinzen” size. These generally measure 30x48mm.
It is unknown how many Fliers Commemorative Badges were awarded, since the original documents were destroyed during the Second World War. Estimates place the number of German recipients at around 300.
Comments
Sign in to comment and reply.
COMMUNITY
ACCOUNT
Scroll Top
